Bias amp 2 stereo2/24/2024 ![]() Its hard for me to compare the sound because Spark is sounding through a built in speaker. Besides the usual amp front panel controls for dialing up distortion and tone, intrepid users can dig in under the hood and make circuit-level changes to the virtual components that govern a particular amp. Software: BIAS Amp 2 Standalone, using the Acoustic Sim, Hiway 103 Clean, and Ecstasy 100 presets. ![]() Interface: Focusrite Scarlett 18i20, input level raised just to the edge of clipping with guitar at max volume, output level maxed. Bias FX has a lot more customization, whereas Spark has a more limited selection of effects. Bias Amp 2, the latest iteration of the comprehensive virtual amp designer from Positive Grid, definitely falls into the latter category. Alright, so I did a test of my setup tonight and here are the results. The default locations are as below:ģ2-bits - C:\Program Files (x86)\VstPluginsĢ) Back to "Devices -> Plug-in information” and make sure if BIAS Amp is in the list and the check box is ticked.ģ) If the steps above are not working, try "Devices -> Plug-in information -> Update Plug-in information" to refresh and see if BIAS Amp shows up on the list. agjones I have used Bias FX in the iPad and have the Spark Amp. Create a new guitar track - Setting - Reset channel Strip - Audio FX - Turn on. I am not sure if this is the right way or professional way to record guitar since I heard electric guitar need to be recorded in 'Mono' instead of 'Stereo'. It was always a ballsy amplifier, with plenty of power and drive, but is now more coherent and offers much more spatial information than before. The default location is: ‘ Library/Audio/Plug-ins/VST/ ’Ģ) Back to "Devices -> Plug-in information” and make sure that BIAS Amp is in the list and the check box is ticked.ģ) If the steps above are not working, click the "Devices -> Plug-in information -> Update Plug-in information” again and see if BIAS Amp shows up on the list.ġ) Launch Cubase/Nuendo, go to ‘Devices -> Plug-in information -> VST 2.0 Plug-in Paths’ and check if the correct location is added. Create a new guitar track - Turn off all the Logic guitar plug-ins - Turn on Bias Amp 2 and choose 'Stereo'. It used to run up to 0.64/0.32 W into 8/4 Ohms in pure class A, but now runs up to 2.55/1.27W into 8/4 Ohms in pure class A and becomes reassuringly warm to touch after half an hour of operation. 1) Launch Cubase/Nuendo, go to ‘Devices -> Plug-in information -> VST 2.x Plug-in Paths’ and check if the correct location is added. Bias FX 2 features 122 effects pedals, 18 rackmount effects units, dedicated Fuzz, Time and Harmonizer modellers, and 100 amplifier and loudspeaker cabinet. I have the problem with my KT88 PP stereo integrated amp to set bias voltages of KT88 of which scheme as below If I set Vk to the same value by adjusting the pots for both tubes, I have audible hum so I cannot set them to the same value but different values, I.e.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |